Product Introduction

VIP1 1B 06 is a single phase power line filter designed to suppress electromagnetic interference on AC power circuits. It features rated voltage of 115 to 250 VAC and maximum rated current up to 6A RMS. The filter achieves excellent common mode noise attenuation across multiple frequency bands under 50 ohm test system. It maintains low leakage current and high insulation strength, with a wide operating temperature range from minus 25 degree Celsius to 100 degree Celsius. With reliable high voltage withstand capability, this filter can effectively restrain electromagnetic interference and help end products meet EMC compliance requirements.

Application Scope and Usage

This power filter is widely used in single phase AC powered electrical and electronic equipment. Typical applications include industrial control devices, power supply units, office automation equipment, medical auxiliary equipment, household electrical appliances and test measurement instruments. It is installed at the AC power input port of equipment to block the transmission of electromagnetic noise between power grid and equipment. It can reduce common mode interference on power lines, protect circuits from external noise disturbance and prevent internal noise of the device from leaking back to the power grid, so as to improve the stability of equipment operation and satisfy electromagnetic compatibility standards.

FAQ

1. What is the maximum rated current of VIP1 1B 06 filter The maximum RMS rated current of this filter is 6A under both 115VAC and 250VAC working voltage. Users should not exceed this current rating during continuous operation.
2. What is the leakage current of this filter The leakage current to ground is maximum 2uA at 115VAC 60Hz and maximum 5uA at 250VAC 50Hz. Low leakage current makes it suitable for devices with strict safety requirements.
3. What is the working temperature range of VIP1 1B 06 The filter can work stably in the environment ranging from minus 25 degree Celsius to 100 degree Celsius. It can adapt to different working conditions with high or low ambient temperature.
4. What is the hipot test requirement for this filter Line to ground can withstand 2000VAC for one minute and line to line can withstand 500VDC. The insulation resistance will keep above 100M ohm at 500VDC between input output and ground.
5. What interference can this power filter suppress This product mainly suppresses common mode electromagnetic interference on AC power lines. It provides good insertion loss in the frequency range from 0.15MHz to 30MHz and helps finished products pass EMC related tests.